aircraft

The light source building. Install the black hot shrink tubing to prevent the light transmitting to outside of fuselage. It is the strobe light module but now I do not konw the specific location of the anti-collision light even through I collected so many pics about the tail cone.

Again The LED can not install into the wing tip because of the narrow space.So I use optiacl fiber.

hi everyone: That's my next step.I want to install navigation lights on both side of wing tip and LH vertical stabilizer.Also install taking-off light and taxi light on nose landing gear and anti-collision light on tail cone. It is just a drawing by hand.I hope I can complete it.

Hi guys, Here comes the landing gear modification works. Replaced some parts with Eduard resin and PE and rebuilt the wires and pipeline clamp with sealing-tap.

Again Refering the Su-27 pictures in airshow we can find out some different configurations about pylons installtion.So I decided to use magnets. Drilled holes on pylons and inside of bottom wings.

I'm afraid you should ues sand paper to lower the height of wheel bay because of you can't put the two fueslage together.

Thanks，Gabor thanks for your so professional knowledge.I will change the color of thrust lever at once.

hi guys: I completed the cockpit yesterday and took these pics from iphone. I don't know what the red wire on the RH control panel is and i don't know the function of this device too.Just add the copper wire colored red followed the cockpit pics downloaded from internet. :wacko:

I know you mean.So I gave up cut the lower fuselage.

Yes,I forgot this.

Again It's so difficult for eduard PE building .The colorized coating cracked and fell off when bent the PE especially. I used resin parts cockpit and seat from aires,instrument panel and safety belts from eduard PE

Please take a look at this picture... IF using the main landing gear bays ,I must cut the red areas as instructions and yellow areas maintain the linkage between fuselage and wings only.I worry about the remained plastic panel is too weak .It's difficult for me to decide cut or not,in view of keep the fuselage stronge I chooes giving up. Thanks for the ways you gave me.

Again I cut the bottom fuselage on nose landing gear area and main landing gear areas. Amazing at the details of aires resin parts! But main landing gear bays bent with red box :bandhead2:/> I gave up cutting the langing gear bay and only cut the wheel bay for replacing,because of I am afraid it will damage intensity of fuselage but also bent landing gaer bay.I only cut some details and build them on original plastic plate...

thanks,

I forgot the PE from dreammodel.Ladder and exterior