ismail okay

Thank you very much. You are right. This was just because of my laziness i did not optimize the photos. I am sorry for that. But now, i changed them with the smaller ones. After that it should not be a problem. Thanks for watching İsmail Okay

ofcourse.. i did not optimize the last photos, loaded directly, sorry you are right. teşekkür ederim erkin :)

You are my hero nicholassagan ... It was a shame for me and you rescued me by showing the way. Thank you very much. I changed the topic name due to your method. Thanks again Cheers İsmail OKAY

thank you so much. yes you are right. i wrote the nickname as flanker as a mistake. it has to be fulcrum of course. please take my apologies for that. but i could not find the link to change the topic name.

It's time to open some ventiles on aircraft.. when i opened one of them, i started to thinning the surface at the back : when doing that i made a decision to try an other method that i never did before. I opened the other ventile area by just thinning the surface... I marked the ventile area by pen on aircraft then i started to dramel it to make thinner surface. Pictures can tell better than i : I will try to open it by just thinning operation. If it works i will not have to do the ventiles again.. But you must be very carefull if you try this. It' s very easy to make an unwanted

then cut them by a sharp knife (the operator doctors' one) -> i found it at my university shop just 2 dollars :) but any knife could be use to do this ofcourse then at the back side of the aircraft i start to dramel it to make the surface thinner. Because thick plastic would not see realistic when finished. Thinning is enough for now. I can continue this if needed at soon. Looks better now : It will be better when sanded. I applied ca to the damaged surface at the upper intake and now waiting to dry to sand the surface... When dried, it will be ready for sanding.

Hello ladies and gentlemen :) UB updates are coming... I made an hole to each ventiles group with dramel to open them

Hello YoungTiger1 .. Thanks for your nice words. Yes i like using electric tools which make the world much easier for a modeler.. I will try my best at that UB. Updates are coming.. Thanks for your watching.. İsmail Okay

Yes you are right. Powertools make the world much more easier for a modeler. I definetely recommend if you don' t have. Greetings İsmail Okay

Thanks for your nice words. I will try my best and share all the details. İsmail OKAY

thanks for your nice words. today i continued the body work of the bird but there is no camera with me tonight :( therefore new pictures will upload tomorrow.

Hi Alexander, Yes Zacto goodies are the parts that would be needed at the project. I agree at you. Thanks for your nice words. I looked at your website and your fulcrums. ..... Amazing... absolutely amazing.. You did very nice works. Cheers, İsmail

Thank you very much... Why not?

The cutting work :) Let' s cut the gun smoke area. This part will be done later. The additional areas to cut. Marked but not cutted yet.. Some aluminium made panel parts at the upper part of the body ... There is a problem because of glue at the top the intake as you can see at the picture. Will be corrected soon.. That's all for now.. Will be continue "probably" tomorrow. Thanks for watching. Comments are welcome. İsmail Okay

oh ****... i saw that i wrote "Flanker" at the headline of the topic.. Sorry for that. It must be Fulcrum of course :( Sorry of my fault..