Search the Community
Showing results for tags 'tamiya 1/48'.
Found 7 results
-
Hello gents, Well, it's been ages since I finished anything and even longer I did post here. So here is an out of the box Corsair of VMF-217, Guam, 1945. Hope you'll like it. Best, Stef (#6) Click images to enlarge :
-
I finished this several months ago, and it's been to a few shows. I used a PE set for the cockpit and then cut styrene to add detail to the rear position. I also scratch built the front and rear of the gear wells, as Tamiya left them open, as well as cut out the wing tip lights and replaced them with plexi. Also Quickboost resin exhausts, although they had to be 'fixed' as there were too many pipes for this aircraft. It was painted with straight Tamiya colors (except for the trainer yellow on the wing leading edges that had to be mixed,) and weathered with preshading and prismacolo
-
Hello again. Still new to this board. I've been around on others (under a different handle 'Thom',) including Starship Modeler, Resin Illuminati and Britmodeler. I've opened up a few other posts, one of my Dinah (put in the wrong section) and another on my S6B. Both in wrong forums... Oh well... But this here is about my Corsair. I finished it about a year ago, using wire to add to the gear bays, a colored PE set for the cockit, and a resin engine and ribs for the cowl. I also used a 7/16'' retaining ring as the ignition ring for the engine, and fashioned clear wingti
-
MM paints with decals from various sources. YAF mossie from early fifties:
-
Hello, here again with this new F-14 and some addons... Wheelliants, pitot tube, PhotoEtch, eduard and Dream Models and some scratch...
-
I have this model of Tamiya since 2012. With changes in the area of my bench I lost at least two pieces. The propeller hub and the pitot tube. I decided to start building the model and go try to find the missing pieces. The model. The chosen scheme will be of an airplane "A4" the 1º scheme of the sheet of the FAB (Brazilian Air Force) using a sheet of decals of the FCM. I started by gluing vertical drift to the fuselage. Best regards ajcmac
-
I have this model of Tamiya since 2012. With changes in the area of my bench I lost at least two pieces. The propeller hub and the pitot tube. I decided to start building the model and go try to find the missing pieces. The model. The chosen scheme will be of an airplane "A4" the 1º scheme of the sheet of the FAB (Brazilian Air Force) using a sheet of decals of the FCM. I started by gluing vertical drift to the fuselage. Best regards ajcmac
