aaronacw Posted March 15, 2009 Share Posted March 15, 2009 Hi, for this GB I am building a 1/200 777-200. When I was filling the windows, i took photos so I could write a tutorial on how to fill windows. All you need is epoxy putty, knife and sandpaper. For this, I am using Tamiya Quick type epoxy putty as I dont know where to get other epoxy putties here. Blend equal amounts of the two putties together until the whole thing is one mass of the same color. Roll a sausage of the putty and lay it against the windows you want to fill Use your finger to press the putty through the windows You should end up with something like this Give the putty 5-10 minuites to dry and cut off the parts that stick out from the outside with a knife. Make sure you dont damage the fuselage by cutting too close. Wait for it to dry hard as per what it says on the instructions and sand it down so that it is smooth, like this Now you're done HTH (back after painting) Aaron Quote Link to post Share on other sites
Samurai_Chris Posted March 15, 2009 Share Posted March 15, 2009 Be carefull using that stuff. Make sure you wear gloves or thoroughly wash your hands after. I prefer to use Tamiya dark grey basic putty, because it is softer, and easier to apply using an old credit card. That quick dry stuff is really for molding and not filling.. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.