lancer3397 Posted February 17, 2012 Share Posted February 17, 2012 (edited) after a few pieces from some 1/72 kits if anyone has spares. can pay paypal. 1/72 Halifax aerial on top of cockpit canopy pitot/aerial under the nose horn balances for ailerons on wing undercarriage doors rod type aerial on lower fuselage under the nose. 1/72 Maruader Mid upper turret including glazing (ideally from an airfix kit if possible) 1/72 Lancaster FN82 type tail turret if anyone has a revell lanc you may have these spare depending on what version you've made. bulged bomb aimers dome main cockpit canopy with high astrodome Paddle blade props + spinners H2S Radome horn balances from rudder aerials from either side of the nose below the cockpit. decals of the aircraft stencils, (no walk lines on upper wings and red jack point indicators on lower wings and fuselage) TIA Edited February 17, 2012 by lancer3397 Quote Link to post Share on other sites
The Artilleryman Posted February 24, 2012 Share Posted February 24, 2012 after a few pieces from some 1/72 kits if anyone has spares. can pay paypal. 1/72 Halifax aerial on top of cockpit canopy pitot/aerial under the nose horn balances for ailerons on wing undercarriage doors rod type aerial on lower fuselage under the nose. 1/72 Maruader Mid upper turret including glazing (ideally from an airfix kit if possible) 1/72 Lancaster FN82 type tail turret if anyone has a revell lanc you may have these spare depending on what version you've made. bulged bomb aimers dome main cockpit canopy with high astrodome Paddle blade props + spinners H2S Radome horn balances from rudder aerials from either side of the nose below the cockpit. decals of the aircraft stencils, (no walk lines on upper wings and red jack point indicators on lower wings and fuselage) TIA Quote Link to post Share on other sites
The Artilleryman Posted February 24, 2012 Share Posted February 24, 2012 I have a pair of Matchbox H2S units from a Halifax and a Lancaster that are yours for the asking. PM me if you are interested. Adios, larry. Quote Link to post Share on other sites
The Loggie Posted February 24, 2012 Share Posted February 24, 2012 G'Day Gunner. Replacement horn balances are easily made. Take fine wire (eg, beading wire - @ $2 at a craft shop), drill into the surface/s, insert the wire/s & secure with superglue, use a length of tube to cut them all to the SAME length, tip the ends with white glue (or similar), finally, use a piece of card (placed flat on the surface) and bend the wire over it. This makes them all parallel to the surface, and all of the horn balances the same. With the Lanc rudder ones, drill straight through, and double-end the wire. The rod-type aerial (towel rail) is similar. Drill onto the belly, insert & glue the wires, use a jig (eg, hole in a 1mm thk plastic card) to cut them all to an identical height, then glue the 'rail' in place with superglue (gel helps to smooth/fill the gaps). Good luck with your search. George, out............... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.