TomcatFanatic123 Posted August 18, 2016 Share Posted August 18, 2016 Are those little intake tips (can't remember the part numbers) always a pain in the keester, or is it just me? I've never done so much damned sanding as I've done on these pieces. I've got them pretty much all blended, still some minor filling to do, but hot damn! They were NOT cooperative. And oddly enough, for the most part, with all the research I did on little workarounds I found on other folks' builds, everything else had actually been fairly cooperative so far (I'll admit I've had to have a few come to Jesus meetings with some areas of assembly, but for the most part it's worked out well...knocking on wood) and an enjoyment to build. Quote Link to post Share on other sites
Darren Roberts Posted August 18, 2016 Share Posted August 18, 2016 The fit is not the best. I had trouble with those as well. After filling and sanding, they looked alright, though. Quote Link to post Share on other sites
TomcatFanatic123 Posted August 19, 2016 Author Share Posted August 19, 2016 Well I will say this, D.Rob, I'm thinking your intake covers will look mighty fine on this thing when it's done. Quote Link to post Share on other sites
Darren Roberts Posted August 19, 2016 Share Posted August 19, 2016 Well I will say this, D.Rob, I'm thinking your intake covers will look mighty fine on this thing when it's done. That's why I made them! :D Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.