Eduard Brassin resin - 1/32 CBU-105/GBU-12 cutting methods

[SILLYMAY]

Hello all,

has anyone tried cutting the pieces for the 1/32 CBU-105 and GBU-12 items yet?

 

I have a small aluminum miter box and a razor saw from UMM and another saw with 54 tpi. The razor saw from UMM is awesome, but the resin part is thicker than the saw blade.

When I glue them together they are not as flush as I would like them to be.  Already tried sanding flat.

The detail on these items are amazing.  It will be very difficult to use filler in these tight areas, but that may be my only option.

 

The 1/32 GBU-24 I have turned out pretty well.  I only started a few, but before I start the others I wanted to see if there were any better methods.

 

Thanks,

Mark

 

 

[viper730]

Yep I have a 48th set and was thinking I,d  cut a bit rotate it cut a bit and keep going around til I got it done? Downside is It may take 3 or 4 360' rotations to get through the thickness of the pour block.