EagleDriver Posted January 20, 2018 Share Posted January 20, 2018 I have used the mask on a canopy. When i removed the mask there was a lot of glue gunk, which i had to remove with alcohol, this resulted in removing the paint also. Did i have a bad/old mask ? How do i resolve this. I have to place a lot of them on my 1/32 TBF tnx, Luc Quote Link to post Share on other sites
Tom G Posted January 20, 2018 Share Posted January 20, 2018 I have had good luck removing glue residue with Novus plastic polish applied with a Q-tip. It’s a paste used to polish plastic and usually takes the glue right off. Tom Quote Link to post Share on other sites
Bob Beary Posted January 21, 2018 Share Posted January 21, 2018 To get into tight areas you can sand a flat toothpick very thin (so it can flex) and use that to apply the Novus polish. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.