Falconxlvi Posted April 2, 2018 Share Posted April 2, 2018 (edited) So, has anyone masked over Archer resin rivets? I’m curious how well they stay down after application and a coat of primer. I’ve got an Ibex T-6 and I am thinking about adding some raised rivet detail, which is very prominent on the aft fuselage and empennage. Thanks, Steve Edited April 2, 2018 by Falconxlvi Grammer Quote Link to post Share on other sites
K2Pete Posted April 3, 2018 Share Posted April 3, 2018 I had no problem with the Archer Rivet decals. But, when I masked 'em I was conscious of not using a sticky tape ... I used a Post It note ... you know, an ounce of prevention ... Hope this helps Pete Quote Link to post Share on other sites
Falconxlvi Posted April 3, 2018 Author Share Posted April 3, 2018 Yea, unfortunately the project I have in mind will require a Star and Bar mask over the top of them. I’m planning on sealing them with primer and a a clear coat before masking - but the mask will be kubuki tape...hmmmmm...I might have to run an experiment on some extra plastic. Your rivets look fantastic by the way! Steve Quote Link to post Share on other sites
cruiz Posted April 15, 2018 Share Posted April 15, 2018 Hello Steve I had no problem either, I've used kabuki tape but, as a precaution, made it less sticky by touching it with my fingers. The rivets were protected with a light coat of Mr. Surfacer before painting. Good luck Carlos Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.