Ripaman Posted April 11 Hi this is my first post on this site, thought I would show you what I did with this Hasegawa 1:24 scale Willys Jeep First off made the steering work Next up was the engine, added some sparkplugs Until next time Regards Richard Share this post Link to post Share on other sites
Ripaman Posted April 13 Next up was to change the seats which did not look right Made these out of brass tube and .003" brass shim Made the hinges work Until next time Regards Richard Share this post Link to post Share on other sites
dnl42 Posted April 13 (edited) Nice soldering work! That steering linkage is quite well done. Did you use Albion Alloy tubes on that? If not, check them out as they have 0.1mm walls, e.g,. 0.3, 0.5, 0.7, 0.9 are a telescoping tubing set. Oh, and welcome aboard! Edited April 13 by dnl42 Share this post Link to post Share on other sites
Ripaman Posted April 13 3 hours ago, dnl42 said: Nice soldering work! That steering linkage is quite well done. Did you use Albion Alloy tubes on that? If not, check them out as they have 0.1mm walls, e.g,. 0.3, 0.5, 0.7, 0.9 are a telescoping tubing set. Oh, and welcome aboard! Thanks for the welcome and yes did use Albion brass tube bought all sizes from .3 to 2 mm I think have the steering work makes for more realistic looks made the white ball by rolling two part epoxy putty and filling to size Regards Richard Share this post Link to post Share on other sites
Ripaman Posted April 13 Made the hitch at the back work by so if needed I can add a trailer Looked at the petrol tank which went on the back bracket I see this is the American one and I am doing this Jeep in Canadian markings I needed a British petrol tank so I changed it up Here is the American This is what I came up with Up next was the wind shield this is what is supplied So out came the brass tube and brass shim and made this Until next time Regards Richard Share this post Link to post Share on other sites