Jump to content
ARC Discussion Forums
  • advertisement_alt
  • advertisement_alt
  • advertisement_alt
Army_Air_Force

My Daughter's Airfix D-Day Battlefront Diorama - with Additions

Recommended Posts

My daughter had a smashing time after school on Wednesday - with a large hammer! To create some more realistic rubble around the diorama, I sent my daughter into the garden to look for some small stones. A few at a time, they were wrapped up in an old T-shirt to stop flying splinters and beaten to death! It created a nice range of colours, shapes and sizes.

 

d_day075.jpg

 

After that, I found a piece of Ramin wood, and sliced it into thin strips on the bandsaw. These would be additional roof timbers from the house, scattered by the blast or cleared by the troops using it. Straight from the saw, the edges had lots of splinters, so I set her off with a sanding block to clean up the strips.

 

d_day076.jpg

Share this post


Link to post
Share on other sites

While she was busy with all that, I masked up the road to paint the paved areas on the base.

 

d_day077.jpg

 

With the tape removed, the streen suddenly looked very clean and fresh! Lots of work would be needed to weather the scene, but it was slowly coming together.

 

d_day078.jpg

Share this post


Link to post
Share on other sites

Once the timbers had been sanded, we got some Humbrol acrylic matt earth and diluted it with some screen wash. 

 

d_day079.jpg

 

After a good stir, the thinned paint made a nice wash/stain to soak the new roof timbers of the house. As it dried, it soaked into the wood, allowing the grain and texture to show through.

 

d_day080.jpg

Share this post


Link to post
Share on other sites

Once the wood had completely dried, it was given a light sand with some 400 grit sandpaper. Some areas were sanded more than others to create variation in the distress of the timbers. The two at the back of the image aren't sanded at all, while the two closer pieces have both hadvarying degrees of sanding.

 

d_day081.jpg

 

As well as roof timbers, we needed some more roof tiles scattered about. I found an offcut of styrene around the same thickness as the kit roof tiles, and set my daughter loose, marking out and cutting some parallel, 4mm wide styrene strips. It took a few goes to get it right, but she got there in the end.

 

d_day082.jpg

Share this post


Link to post
Share on other sites

I mixed up some red/brown for the tiles and she painted the strips. Once dry, they can be cut into single tiles and will only need a slight touch up on the edges. I also painted the left over, wider strip after she was done, to give us a bit of spare tile material.

 

d_day083.jpg

 

While she had been doing those, I painted the sandbags and other walls on the vac-formed base in a base colour. Rubble and other debris will probably be the next job to attach in the next build session. Another two and a half hours had gone and that was the end of this week's build session.

 

d_day084.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×