Breaddy-Stack Posted July 10, 2020 Share Posted July 10, 2020 (edited) I had an Aires seat that came with the pull handle broken off and I also have a few kits with lackluster seats as is. I saw a trick on YouTube that uses wire to make a handle, I just don’t know what gauge should be good to buy! I’m working in 1/48 scale if that helps! Edited July 10, 2020 by Breaddy-Stack Quote Link to post Share on other sites
A-10 LOADER Posted July 21, 2020 Share Posted July 21, 2020 Not really sure of the gauge of the wire but, I use copper wire that fits a #77 ( .0180" ) or a #78 ( .0160" ) drill bit. It all depends on what seat your doing and picking a wire that looks to scale for that seat as well. Hope this helps. Steve Quote Link to post Share on other sites
Breaddy-Stack Posted July 21, 2020 Author Share Posted July 21, 2020 1 minute ago, A-10 LOADER said: Not really sure of the gauge of the wire but, I use copper wire that fits a #77 ( .0180" ) or a #78 ( .0160" ) drill bit. It all depends on what seat your doing and picking a wire that looks to scale for that seat as well. Hope this helps. Steve Ahh this definitely helps! For the seat in question was an SJU for an F/A-18A in 48th scale! I’ll check those out though! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.