320 Driver Posted October 28, 2020 Share Posted October 28, 2020 So I've painted wings and fuselages light grey (Mr Color) and would like to figure out the best way to wash the panel lines and control surfaces so they pop out a bit. I tried Testors Acrylic Wash on a practice piece and it was not pretty. Any suggestions? Quote Link to post Share on other sites
Bob Beary Posted October 29, 2020 Share Posted October 29, 2020 You need a gloss finish for a wash to work as desired. If your finish was flat, that may have been the problem. Quote Link to post Share on other sites
dylan Posted November 1, 2020 Share Posted November 1, 2020 overspray with either future or Tamiya X-22 the wash will not attack them. I usually thin the tamiya 50/50 with tamiya lacquer thinner. again try it out on a test piece first Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.