Jump to content

Recommended Posts

@aircommando130 @BastianD @Mr.Happy Thank you!  @Bendinggrass you can check out my wings progress pix posted in this thread previously.  I basically cut out the part for leading edge slat and flap from the top and bottom wing part.  I used putty , styrene sheet (from 0.1 to 0.3mm thickness), 1.5mm I-beam styrene as well as lot of sanding to scratch build thinner flap and flap tracks respectively.  

 

Link to post
Share on other sites
12 minutes ago, Badmofo said:

@aircommando130 @BastianD @Mr.Happy Thank you!  @Bendinggrass you can check out my wings progress pix posted in this thread previously.  I basically cut out the part for leading edge slat and flap from the top and bottom wing part.  I used putty , styrene sheet (from 0.1 to 0.3mm thickness), 1.5mm I-beam styrene as well as lot of sanding to scratch build thinner flap and flap tracks respectively.  

 

Thanks so much. Much appreciated.

R

Link to post
Share on other sites
  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...