Dog1 Posted March 17, 2021 Share Posted March 17, 2021 hello I wetted a decal and while transfering it folded on itself and i cannot get it to unfold again , its a small cockpit gauge size . i have left it in warm water hoping it will open . Can anyone please give any other suggestion .thanks . Quote Link to post Share on other sites
72linerlover Posted March 17, 2021 Share Posted March 17, 2021 Hi, Dog1 Welcome to the CODWA (Club Of Decal Warping Accidents) and to the Forum. When it happens, I take the decal out of the water with a brush. I mix a drop of dish wash in few water (say 1/30 ratio) and soak the brush with the decal on it. (the dish wash lowers the surface tension and helps the surfaces to separate) 50% works, but it is whort to try. Good luck Euge Quote Link to post Share on other sites
RichardL Posted March 17, 2021 Share Posted March 17, 2021 Can you try opening up the decal still left in warm water with a small fine brush? Quote Link to post Share on other sites
Dog1 Posted March 18, 2021 Author Share Posted March 18, 2021 i tried everything but it would not open up . now i have to look for an after market gauge sheet . Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.