mrvark Posted June 22, 2021 Share Posted June 22, 2021 Just a quick tip. When making Reskit resin nozzles, most of the cutting to free the parts from their casting blocks is pretty straight-forward. However, the afterburner flame holders are a bit of a challenge. These parts are three-dimensional in that they are conically shaped. I've tried cutting them free and am here to warn you not to do that--you'll probably end up damaging the parts (at least, if you're as clumsy as I am)! Instead, get a corse sanding stick and sand the excess away gradually. It's time consuming and messy, but the part will end up intact and you won't beat your head against a wall for being an idiot--a much better outcome. Here are a couple of pictures illustrating the point. Quote Link to post Share on other sites
Helmsman Posted June 23, 2021 Share Posted June 23, 2021 Sharp knife works very well on these parts. Quick and easy, with no damage. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.