Cloud in the Wind Posted August 18, 2022 Share Posted August 18, 2022 Any of you small scale builders have a recommendation for how I might scratch build the head-rest ejection seat handles? I tried to ring wire and cut paper but didn’t like the results. Hoping there’s an alternate method or technique. Quote Link to post Share on other sites
spejic Posted August 18, 2022 Share Posted August 18, 2022 (edited) I used very fine wire. I wrap it around a toothpick because the tapered tip lets me chose the diameter and can be slipped off easily. I paint it yellow and apply the black stripes with a fine Micron technical pen. Your first tries will certainly be too big, but keep trying. This is a seat from a 1/144 Revell F-104G, but the principle is the same. Edited August 18, 2022 by spejic Quote Link to post Share on other sites
Cloud in the Wind Posted August 28, 2022 Author Share Posted August 28, 2022 Thank you sir, but I'm going to have to practice quite a bit more. I wasn't able to get the rings to work anywhere nearly as well as was worth adding to my build. But you certainly gave me good advice. Love the templates too. Quote Link to post Share on other sites
toadwbg Posted January 7, 2023 Share Posted January 7, 2023 1/144 is a pretty small scale for these. Have you tried wrapping black&yellow thread and coating with a clear glue? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.