JohnG Posted September 11, 2003 Share Posted September 11, 2003 I've got some resin machine guns and they're a bit bent and twisted in spots. Can I just dip it hot water and treat it like plastic? Or is there another technique? Quote Link to post Share on other sites
Kasatka Posted September 11, 2003 Share Posted September 11, 2003 yes, you can Quote Link to post Share on other sites
Swanny Posted September 11, 2003 Share Posted September 11, 2003 Get your tap water running as hot as possible then hold part in the hot stream until it acquires the temperature, gently bend towards desired shape and submerge in cold water. May have to repeat this more than once for larger pieces with severe bends. Quote Link to post Share on other sites
JohnG Posted September 12, 2003 Author Share Posted September 12, 2003 Sounds good, thanks. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.