Jump to content

Recommended Posts

Thanks alot fellas.

Wie gehts Chris :cheers: The exhaust shields are the kit parts after

some scraping and filing. I also shortened the overhang on the port

side as I thot it covered too much of the exhaust per many photos

I looked at.

Hey Dave, the spinner was quite a project in it's self. First I glued

the backplate on with temporary glue (Microscale Liquitape) then

chucked it in my old dremel and reshaped it to look more pointy

like it should. I drilled out the cannon and replaced it with a piece

of aluminum tubing for the blast tube. I painted the spinner black

enamel so I could remove any booboos I made with the white acrylic

later. I needed veerrry thin strips of tape to conform to the compound

curve so I laid down 2 real thin strips, one for each side of the stripe

then brush painted Aim toothpaste (gel) between them and shot the white.

It worked pretty well and I only had a coupla places that needed fixing.

Then shot it with several coats of MM clear flat and gloss mixed for a

semi gloss sheen and to level things out. Not really difficult, just tedious.

Mike

a

b

e

n

...thanks again all.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...