Mike T. Posted August 3, 2003 Share Posted August 3, 2003 Just wondering should I let all the air out of my compressor after I'm done with it for the day? Quote Link to post Share on other sites
Sabre Posted August 3, 2003 Share Posted August 3, 2003 On larger units, it would be a good idea, since the moisture trapped inside could, eventually cause a rust spot and lead to tank failure. This would occur while the unit was under pressure. Need not tell you the effects of such an action. Smaller units would benefit from regular bleeding, as well. Safe modeling, Jim Quote Link to post Share on other sites
Steve Filak Posted August 3, 2003 Share Posted August 3, 2003 I'm not sure if it needs to be done each and every time, but I usually bleed my tank about once a week. Usually, you'll only get a few drops of water to come out, but it's better on the workshop floor than it is inside your air tank, rusting it out from the inside..... ;) Quote Link to post Share on other sites
Mike T. Posted August 5, 2003 Author Share Posted August 5, 2003 Ok thanks....Hadn't considered moisture inside the tank... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.